What resolutions are supported as outputs on the new slot loading BLURAY player? The FD932DVD-BLU-2 will support up to 1080p via the HDMI or 1080i via the HDSDI output. It will support up to 576i when selected to PAL output on the composite connector. Due to the microchip installed, the ability to simulcast is limited […]
If you are not happy with the results below please do another search
17 search results for:
These instructions apply to any of our products that use a ferrite, including the FD932DVD-LP-2 and the FD932DVD-LP-2-AV.
The maximum output voltage of the FD932DVD-LP-2 is 1 volt. If you are trying to run extra speakers off of the FD932DVD-LP-2 you will need an amplifier.
The FD932DVD-LP-2 and FD932DVD-LP-2-AV from Flight Display Systems accepts discs with the following:
The FD932DVD-BLU does not require any AACS updates.
The message DISC ERR is usually displayed when the unit ca see the disc but not play the disc. This usually occurs when the disc is scratched or dirty. The message NO DiSC is displayed when the unit simply can not read or detect the disc at all. This can also occur if the disc […]
Our DVD players will cycle the video inputs in order, depending on where you begin. DVD SD Card USB repeat … DVD
The Aux/DVD switch allows changing between the DVD inside the unit and an auxiliary input from either the front inputs, or the inputs through the DB9 connector on the back. It will not allow simultaneous input from both. The composite video and audio outputs on the back of the unit are ONLY for the DVD. […]
This is the receiver eye for the remote control.